getting frame ready for powder coat. as of now ive cut rails. had short necked removed all brackets and the forward support in frame. I also milled out the inside of the frame right above where the trans sits ..."lightend"... what else should I do before sending to powder.. I want to add two brackets in the pocket I milled to mount my nos noids if I go that direction.. and I probably need to set up for mounting fuel system parts... just want to make sure ive hit everything and iam not missing anything.... like say if I go with a stroker engine.. what needs to happen to the frame to get the upper bolts to work??? as of now ive got an dme fairing stay for fuel cell and maybe bat box.. I want to mount the black box(relay center) iam looking at buying a dme subframe and rear sets.. as of now all bolts ive used to install are titanium and plan to continue that.. but having trouble finding the longer engine bolts and some of the suspension bolts:2thumbs:
thanks for the help with the planning might even consider running wiring harness within frame where possible.... Plan on building this as best as I can frame wise... still debating on wheel choice... do I go r1 or go all out with bst.. is iot really worth the funds. even considering designing my own sub frame 1/2 aluminum 1/2 carbon fiber. just a few thoughts thanks for input
thanks for the help with the planning might even consider running wiring harness within frame where possible.... Plan on building this as best as I can frame wise... still debating on wheel choice... do I go r1 or go all out with bst.. is iot really worth the funds. even considering designing my own sub frame 1/2 aluminum 1/2 carbon fiber. just a few thoughts thanks for input